Regulátor Elementair-E MARK I slouží k plynulému řízení otáček EC ventilátoru a teploty v prostoru. Jeho SW je optimalizován pro ovládání provozu vzduchových clon a vytápěcích jednotek s EC motory.
Pohledný design umožňuje použití i v komerčních prostorech.
Doporučená montáž
Regulátor Elementair-E MARK II se doporučuje montovat do výšky cca 1,5 m od podlahy na stěnu nebo na instalační podomítkovou krabici. Nedoporučujeme instalovat regulátor Elementair-E MARK II v místech, kde je průvan a poblíž významnějších zdrojů tepla.
Velikost regulátoru
výška 85 mm
šířka 85 mm
hloubka 30 mm
Spring terminals with manual wire locking are used to connect the wires. A strand-type conductor (cable) and a solid conductor (wire) in the cross-section range from 0.5 to 1.5 mm² can be installed in the terminals.
Spring terminals with manual wire locking are used to connect the wires. A strand-type conductor (cable) and a solid conductor (wire) in the cross-section range from 0.5 to 1.5 mm² can be installed in the terminals.
Description of control logic:
required temperature control (space reheating) at the required flow according to the user's choice
the device runs at a preset speed by the user, after reaching the required temperature the device switches off.
the valve with the drive is open - the device is heating, the valve control is in the switching logic with the fan (the device is switched off, the valve is closed).
the "Door Switch" contact is connected (sensing the opening of doors, gates, windows, etc.):
open (eg door open) - the device starts at max. speed, ignores the room thermostat setting. The heating is always full - the valve is open
closed (eg door closed) - the device returns to the thermostat control mode, ie. that the device returns to the set speed
user and is controlled by a room thermostat according to the ambient temperature and the required temperature
